#GCKUPROXL Supplemental Instructions

This is just a supplement, with a picture for helping in your installation, for full instructions go to;

General Installation Instructions.

Instructions for Accelerator bracket mounting on the Kubota 60 inch Pro series rider.
Disregard the bracket mounting instructions on the back of the standard catcher manual.

1) Place the bracket as shown on the edge of the mower deck. It should be flush to the edge at the front, slightly away from flush at the rear (this gives a slight outward angle to the catcher, keeping it away from the rear tire).

2) Clamp the bracket in place with a C clamp or other suitable device.

3) Drill 2 5/16 holes through the top of the bracket and down through the mower deck. Space the holes at least 3 inches apart (the holes are not visible in the picture. They are behind the upraised portion of the bracket).

4) Use the enclosed stainless steel nuts and bolts to attach the bracket.

5) Attach the catcher by placing the horizontal pin on the catcher through the hole in the bracket, engaging the hook on the catcher over the top of the bracket.

Note: The deflector shield will not deploy properly when the Accelerator bracket is attached. If you are going to use the mower without the catcher, be sure to remove the Accelerator Bracket and reattach the deflector shield. Using your mower without a catcher or deflector shield properly installed is very hazardous.