Home . . About Accelerator . . Where can you get a catcher. .Application Chart/Model Listing. . Mounting Instructions. . .Contact us. . . Sitemap

GC21TO Installation Instructions

This bag is intended for use by professionals only. It fits only Toro® and Exmark® 21 inch commercial lawn mowers. It is not intended for use on any other mowers. Attempting to use this product on other mowers is hazardous.

Preparing your mower:

a) Make sure the mower control cables are out of the way. If they catch on the bag when you are putting it in, use tape (duct tape works well) to secure the cables to the outside of the mower handle. Make sure the bolts securing the handle of the mower to the mower deck are pointing outward so the bag won’t hang up at the bottom.

Installation instructions:

a) release blade clutch and throttle down engine (be sure blade is disengaged)

b) Holding the bag by the center handle, lower it into place, so that the hole in the flange at the front top of the bagger seats over the post at the top of the chute on the mower.

c) Grasp and pull the handle on the discharge chute of the mower until the securing pin seats on the aluminum catcher.

* The bag must be installed by lowering it into place. Do not attempt to bring the bag up under the handles.

 

Safety:

Be sure the bag does not become so heavy that the mower tips in any way. generally this will be a problem when the grass is wet. If you feel that the mower is becoming unbalanced, empty the bag right away. Also, do not put extra weight on top of the bag as it may cause the mower to tip. Tipping can also be a problem when mowing on slopes. The fuller the bag is the less stable the mower will be on slopes.

Be sure to read the safety instructions on the warning label (or on the reverse side of this page)

Warning! FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS INJURY.

Read the catcher owner's manual before using or installing this product. Improper installation can cause hazards.
Follow all the safety instructions provided with your lawn mower.
Never use your mower without the catcher or original grass deflector fully installed.
If your deflector shield cannot fully deploy with a catcher bracket mounted, remove you catcher bracket before using your mower without the catcher.
Always use eye protection when operating your lawn mower.
Keep others away from the mowing area.
Do not use this catcher if you cannot safely lift heavy loads. Use proper lifting techniques.
be sure the blade has stopped moving before removing or installing the catcher.
Use caution when mowing on slopes. The fuller and heavier the catcher is the more likely the mower is to tip over or slip.
Don’t use this catcher if it is cracked or damaged.
Don’t use your hands inside the catcher. You may be cut or scratched.

info@acceleratorindustries.com . . . . 1-800-984-9410

Home . . About Accelerator . . Where can you get a catcher. .Application Chart/Model Listing. . Mounting Instructions. . .Contact us. . . Sitemap


Copyright- Accelerator Industries® Last revised: March 4, 2004