Each catcher comes with mounting instructions specific to that catcher. All catchers have a general information sheet that provides catcher care direction and basic instructions. If your catcher comes with a bracket in the box, then you will also receive specific bracket installation instructions.
It is your responsibility to read the warnings below and follow the provided instructions.
TOOLS NEEDED IF A BRACKET IS REQUIRED:
Remove the deflector shield assembly if necessary to provide room to mount the catcher. Place the catcher and the bracket together on the deck. The bracket will sit flush to the face of the discharge opening. When the catcher intake is aligned with the mower discharge, mark the bracket placement. Clamp the bracket in place and drill four 5/16” holes through the bracket and the deck. Insert the hardware and tighten it. Insert the pin into the hole and lower the back of the catcher until the hook seats onto the rear bracket lip.
