Each catcher comes with mounting instructions specific to that catcher. All catchers have a general information sheet that provides catcher care direction and basic instructions. If your catcher comes with a bracket in the box, then you will also receive specific bracket installation instructions.
It is your responsibility to read the warnings below and follow the provided instructions.
TOOLS NEEDED IF A BRACKET IS REQUIRED:
Remove the deflector shield assembly if necessary to provide room to mount the catcher. This bracket will sit inside the discharge opening (not on top of the deck). Clamp the bracket in place. Hold the catcher up to the opening, ensuring the catcher intake aligns with mower discharge. Tweak placement if necessary. Drill two 5/16” holes through the bracket and the deck. Insert the hardware and tighten it. Insert the pin into the hole and lower the back of the catcher until the hook seats onto the rear bracket lip.
